Sling lounge chair – A folding lounge chair with a harness back is a classic piece of outdoor furniture. The loose fabric is as comfortable as a hammock. Sunshine and moisture are hard on outdoor fabrics, but you can save an old chair frame by replacing the harness. Outdoor fabrics are available in many modern prints. Use bold stripes or colorful dots to add a modern touch to a classic chair. Choose cotton canvas for comfort or a synthetic fabric outdoors for durability.
Ideas for replace sling lounge chair, take the seams that hold the lift back to the bars at the top of the seat back and in front of the chair frame. Lay the lifting platform flat and measure its length and width. Flat the covers where you removed the stitches, but do not remove the side stools or the cuffs at the ends of the casing. Cut a piece of cloth or other outdoor fabric 1 inch wider and longer than the old seal. Install a sew denim machine needle in the sewing machine and wipe the machine with a nylon sheath thread. Set the machine to sew a regular zigzag and sew along the side seams.
Then to replace sling lounge chair, make half-inch creases on both sides of the sling and pin them in place. These will be hails on the sides of the harness. Set the machine to sew a straight stitch with a standard stitch length, and sew in place by sewing 3/8 inch from the stitch. Set the machine to sew a zigzag stitch and sew along the upper and lower edges of the belt. Iron and half inches times on both the top and bottom sides. Pull a cloth needle with 16 inches of garment wire, and tie the ends together. Wrap the upper folded edge around the bar at the top of the back of the chair. Hand sews the seat to the chair; sew 1/8 inches from the folded edge. When you reach the end of the seam, sew back in the other direction to the starting point, which needle up through the holes you walked through and through the holes you walked through. Attach the lower end of the lifting belt in the same way as you attached the top.